Pioneer DEH-P5500MP Manuel d'utilisateur télécharger pdf (Page 42)

3 Press a or b to adjust the output level

of the subwoofer.

Each press of a or b increases or decreases

the level of the subwoofer. +6  6 is displayed

as the level is increased or decreased.

Using non fading output

When the non fading output setting is on, the

audio signal does not pass through this units

low pass filter (for the subwoofer), but is out-

put through the RCA output.

1 Press AUDIO to select non fading out-

put on/off setting.

Press AUDIO until NOFAD:ON appears in the

display.

# When the subwoofer controller setting is only

P/O :FUL, you can switch to the non fading out-

put on/off setting. (Refer to page 45.)

2 Press a to turn non fading output on.

NOFAD:ON appears in the display. Non fading

output is now on.

# To turn non fading output off, press b.

Adjusting non fading output level

When the non fading output is on, you can ad-

just the level of non fading output.

1 Press AUDIO to select non fading out-

put setting.

Press AUDIO until NOFAD: 0 appears in the

display.

2 Press a or b to adjust the output level

of the non fading.

Each press of a or b increases or decreases

the level of the non fading. +6  6 is displayed

as the level is increased or decreased.

Using the high pass filter

When you do not want low sounds from the

subwoofer output frequency range to play

from the front or rear speakers, turn the HPF

(high pass filter) on. Only frequencies higher

than those in the selected range are output

from the front or rear speakers.

1 Press AUDIO to select HPF.

Press AUDIO until HPF appears in the display.

2 Press a to turn high pass filter on.

HPF : 80 appears in the display. High pass fil-

ter is now on.

# If the high pass filter has been previously ad-

justed, the frequency of that previously selected

will be displayed instead of HPF : 80.

# To turn high pass filter off, press b.

3 Press c or d to select cut-off frequency.

Each press of c or d selects cut-off frequen-

cies in the following order:

5080125 (Hz)

Only frequencies higher than those in the se-

lected range are output from the front or rear

speakers.

Note

If you switch the SFEQ setting, the HPF function

is automatically turned off. By turning the HPF

function on after selecting the SFEQ setting, you

can combine HPF function with SFEQ

function.

Adjusting source levels

SLA (source level adjustment) lets you adjust

the volume level of each source to prevent ra-

dical changes in volume when switching be-

tween sources.

! Settings are based on the volume level of

the FM tuner, which remains unchanged.

Audio Adjustments

En

42

Section

09

HHHHHHHHHHHHHH

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 115 116

Commentaires sur ces manuels

Pas de commentaire