Pioneer GM-D9500F Manuel d'utilisateur Page 14

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 104
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 13
Specifications
Power source ............................. 14.4 V DC (10.8 V to 15.1 V
allowable)
Grounding system ................... Negative type
Current consumption ............ 25 A (at continuous power,
4 W)
Average current drawn ......... 7.9 A (4 W for four channels)
10.5 A (4 W for two chan-
nels)
10.7 A (2 W for four chan-
nels)
Fuse ................................................ 40 A × 1
Dimensions (W × H × D) ... 245 mm × 56 mm × 200
mm
Weight .......................................... 2.2 kg (Leads for wiring not
included)
Maximum power output ....... 150 W × 4 (4 W)/400W×2
(4 W)
Continuous power output ... 75 W × 4 (at 14.4 V, 4 W,20
Hz to 20 kHz, 1% THD)
200 W × 2 (at 14.4 V, 4 W
BRIDGE, 1 kHz, 1% THD)
100 W × 4 (at 14.4 V, 2 W,1
kHz, 1% THD)
Load impedance ...................... 4 W (2 W to 8 W allowable)
(Bridge connection: 4 W to 8
W allowable)
Frequency response ............... 10 Hz to 35 kHz (+0 dB, -3
dB)
Signal-to-noise ratio ............... 95 dB (IEC-A network)
Distortion ..................................... 0.06 % (10 W, 1 kHz)
Separation .................................. 67 dB (1 kHz)
60 dB (100 Hz to 10 kHz)
Low pass filter:
Cut off frequency ........... 40 Hz to 500 Hz
Cut off slope ..................... -12 dB/oct
High pass filter:
Cut off frequency ........... 40 Hz to 500 Hz
Cut off slope ..................... -12 dB/oct
Gain control:
RCA ...................................... 200 mV to 6.5 V
Speaker .............................. 0.8 V to 10 V
Maximum input level / impedance:
RCA ...................................... 6.5 V / 22 kW
Speaker .............................. 10 V / 22 kW
Notes
! Specifications and the design are subject to
modifications without notice.
! The average current drawn is nearly the maxi-
mum current drawn by this unit when an
audio signal is input. Use this value when
working out total current drawn by multiple
power amplifiers.
Additional information
En
14
Appendix
Vue de la page 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 103 104

Commentaires sur ces manuels

Pas de commentaire