Pioneer DEX-P99RS Manuel d'utilisateur Page 36

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 75
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 35
When delays occur for low sounds due
to the influence of the LPF on active
subwoofers or external amps.
! Auto TA and EQ changes the audio settings
as below:
The balance settings return to the center
position. (Refer to page 28.)
The graphic equalizer curve switches to
FLAT. (Refer to page 32.)
! If you carr y out auto TA and EQ when a pre-
vious setting of this already exists, the set-
ting will be replaced.
! When connecting tweeters, please confirm
the tweeters usable frequency range.
When you set the cut-off frequency, set
higher than the lowest usable frequency of
the tweeter.
! Auto TA uses higher range than 10 kHz for
measurement. Therefore, using the tweeter
that cannot reproduce 10 kHz frequency
range may damage the tweeter. When Auto
TA&EQ is operated, be sure to set the ap-
propriate cut-off frequency. Also, use the
tweeter that can reproduce 10 kHz at the
lowest usable frequency.
! Speakers used with this system need to be
activated in the initial setting menu. Refer
to Setting the speakers on page 38.
! To perform auto-time alignment and auto-
equalizing, be sure to connect speakers to
mid range output.
Carrying out auto TA and EQ
1 Stop the car in a place that is as quiet
as possible, close all doors, windows and
the sun roof, and then turn the engine off.
# If the engine is left running, engine noise may
prevent correct auto TA and EQ.
2 Fix the supplied microphone in the cen-
ter of the headrest of the drivers seat, fa-
cing forward, using the belt (sold
separately).
# The auto TA and EQ may differ depending on
where you place the microphone. If desired, place
the microphone on the front passenger seat to
carry out auto TA and EQ.
3 Turn the ignition switch to ON or ACC.
# If the cars air conditioner or heater is turned
on, turn it off. Noise from the fan in the air condi-
tioner or heater may prevent correct auto TA and
EQ.
# Press SRC/Off to turn the source on if this
unit is turned off.
4 Press SRC/Off and hold until the unit
turns off.
5 Press and hold EQ to enter the auto TA
and EQ menu.
The front panel opens automatically.
6 Plug the microphone into the micro-
phone input jack on this unit.
7 Turn MULTI-CONTROL to select
Select position in the auto TA and EQ
menu.
Audio Adjustments
En
36
Section
03
Vue de la page 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 74 75

Commentaires sur ces manuels

Pas de commentaire