Pioneer CD-PC1 Manuel d'utilisateur télécharger pdf (Page 9)

Installing the Program

The PC LinkKit cannot be started from the CD-ROM.

It is necessary to first install the program to the hard disk of your PC. Before installing the program,

close all other applications.

z Insert the included CD-ROM into the CD-ROM drive.

The Install Shield Wizard will automatically appear.

Note:

• If the Install Shield Wizard does not appear, click “Start” and select “Run”. In the name box, enter

the drive letter of the CD-ROM drive (“D” if the CD-ROM drive is D), colon (:), backslash (\) and

then “setup”. (For example, “D:\setup”).

x Check the content and click “Next”.

The License Agreement will appear. (The content can also be found on page 2 of this manu-

al.)

c After reading the content, select “I accept the terms in

the license agreement” and click “Next”.

v Specify the install destination and click “Next”.

b Click “Install” to install the program.

n Click “Finish”.

Now the program has been installed. If the install destination was not specified in step 4, the

program will be registered in the Programs folder of the Start menu under the name of

“Pioneer”.

Removing “LinkKit” (Uninstall)

To remove “LinkKit” from your PC, uninstall the program using the following procedure.

z Open the Control Panel of Windows.

x Double click “Add/Remove Programs”.

c Select “LinkKit” and click “Add/Remove”.

v Follow the onscreen guidance.

Now, the program has been removed from your PC.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Pas de commentaire

Pioneer CD-PC1 Manuel d'utilisateur Page 9