Pioneer AVIC-S2 RU Manuel d'utilisateur télécharger pdf (Page 67)

5.6.3.2 Enable Overview mode

You can configure how the Overview mode is triggered when the next turn is at a

distance.

The Route event distance will determine when AVIC-S2 switches to the Overview or

back to the Navigation view.

The Overview zoom level will determine the fixed zoom level of the map in both

automatic and manually selected (by the Map orientation icon – see here: Page 29)

Overview modes. You can change the zoom level manually at any time (the Lock

button will not be displayed), but when you enter the Overview mode again, the

zoom level will be reset to this value.

You can also move the map in Overview mode. Then the Back button will appear,

and when pushed, it will move the map to have your current position in the middle

again.

Note: when this automatic feature is disabled, you can still enable the Overview

mode manually as described here: Page 29.

5.6.3.3 Keep position on road (Lock-on-Road)

AVIC-S2 is normally used for vehicle navigation, therefore Lock-on-Road will display

the position arrow precisely over roads, seamlessly correcting small GPS errors.

Note: By turning off Lock-on-Road you also turn off the GPS position error filtering.

The position shown on the map will be subject to all position errors and position

fluctuations.

5.6.4 Set Favourite Destinations

You can select two of your most frequent destinations to be your favourites (Page

79). You can start navigating to either of them by only two taps on the screen. The

original names of these points are Home and Office.

You can rename them and specify their locations. To determine the location you can

use the same Find menu options (Page 70) as for a route destination, and

depending on that choice and the information available, the location will be shown

here as a street address, a latitude/longitude position, or both.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 83 84

Pas de commentaire

Pioneer AVIC-S2 RU Manuel d'utilisateur Page 67