Pioneer AVIC-HD1BT Manuel d'utilisateur télécharger pdf (Page 10)

Connecting the System

Connecting the power cord (1)

Connect leads of the same

colour to each other.

Cap (*1)

When not using this terminal,

do not remove the cap.

ISO connector

Fuse (10 A)

Yellow (*2)

To terminal always supplied

with power regardless of

ignition switch position.

Red (*4)

To electric terminal controlled

by ignition switch (12 V DC)

ON/OFF.

Yellow (*3)

Back-up

(or accessory)

Red (*5)

Accessory

(or back-up)

Black (earth)

To vehicle (metal) body.

Orange/white

To lighting switch terminal.

Note:

In some vehicles, the ISO connector

may be divided into two. In this case,

be sure to connect to both connectors.

Note:

Depending on the kind of vehicle, the

function of *3 and *5 may be different.

In this case, be sure to connect *2 to *5

and *4 to *3.

Speaker leads

White: Front left +

White/black: Front left ≠

Grey: Front right +

Grey/black: Front right ≠

Green: Rear left + or Subwoofer + (*9)

Green/black: Rear left ≠ or Subwoofer ≠ (*9)

Violet: Rear right + or Subwoofer + (*9)

Violet/black: Rear right ≠ or Subwoofer ≠ (*9)

Yellow/black

If the vehicle can send a mute signal to this terminal,

the mute function can be activated on this navigation

system when the terminal is connected to *8.

Note:

When a subwoofer (*9) is connected to this naviga-

tion system instead of a rear speaker, change the

rear output setting in the Initial Setting. (Refer to

the Operation Manual.) The subwoofer output of

this navigation system is monaural.

When replacing the fuse, be sure to only use a

fuse of the rating prescribed on the fuse holder.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 169 170

Commentaires sur ces manuels

Pas de commentaire

Pioneer AVIC-HD1BT Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Multimédia automobile Pioneer AVIC-HD1BT