Pioneer AVIC-F840BT Manuel d'utilisateur télécharger pdf (Page 160)

Setting the rear output

The navigation system’s rear output can be

used for a full-range speaker or subwoofer

connection. If you switch “Rear SP” to

“Sub. W”, you can connect a rear speaker lead

directly to a subwoofer without using an auxili-

ary amp.

Initially, the navigation system is set for a rear

full-range speaker connection (“Full”).

p Both rear speaker leads output and RCA

rear output are switched simultaneously in

this setting. (When you use the product

without RCA rear output, this setting only

applies to the rear speaker leads.)

p “Rear SP” can be set only when the source

is selected to “Off”.

p AVIC-F840BT is not compatible with the wir-

ing that the subwoofer is directly con-

nected to rear speaker leads. Always use

the setting with “Full”.

1 Display the “AV System Settings”

screen.

= For details, refer to Displaying the screen for

AV system settings on page 158.

2 Touch [Rear SP].

Each touch of [Rear SP] changes the settings

as follows:

! Full

When no subwoofer is connected to the

rear output, select “Full”.

! Sub. W

When a subwoofer is connected to the rear

output, select “Sub. W”.

Switching the preout setting

CAUTION

Ensure the output setting of “Preout” is the same

as the speaker connected.

p This function is available for AVIC-F840BT

only.

You can switch the output setting of the preout

of this navigation system to the subwoofer or

rear speaker.

p “Preout” can be set only when the source

is selected to “Off”.

p If you set “Rear SP” to “Sub. W”, you can-

not conduct the setting of “Preout”.

1 Display the “AV System Settings”

screen.

= For details, refer to Displaying the screen for

AV system settings on page 158.

2 Touch [Preout].

Each touch of [Preout] changes the settings

as follows:

! Sub. W (default):

When a subwoofer is connected to the pre-

out outputs (SWL, SWR), select “Sub. W”.

! Rear

When rear speaker is connected to the pre-

out outputs (SWL, SWR), select “Rear”.

Switching the muting/

attenuation timing

You can mute the AV source volume or attenu-

ate the output signal.

p Even if this setting is “Off”, the navigation

system will mute or attenuate the AV

source volume when the mute signal is out-

put via MUTE lead.

1 Display the “AV System Settings”

screen.

= For details, refer to Displaying the screen for

AV system settings on page 158.

2 Touch [Mute].

Each touch of [Mute] changes the settings as

follows:

AVIC-F40BT

! Guide/Tel/VR: The volume is muted or atte-

nuated according to the following condi-

tions.

— When the navigation outputs the gui-

dance voice.

Engb

160

Chapter

27

Customising preferences

1 2 ... 155 156 157 158 159 160 161 162 163 164 165 ... 219 220

Commentaires sur ces manuels

Pas de commentaire