Pioneer AVIC-F20BT Manuel d'utilisateur télécharger pdf (Page 132)

Rear view camera

The navigation system features a function that

automatically switches to the full-screen

image of the rear view camera installed on

your vehicle. When the gear stick is in the RE-

VERSE (R) position, the screen automatically

switches to full-screen rear view camera

image.

Camera for Rear view mode

“Rear View” can be displayed at all times (e.g.

when monitoring an attached trailer, etc.) as a

split screen where map information is partially

displayed. Please be aware that with this set-

ting, camera image is not resized to fit, and

that a portion of what is seen by the camera is

not viewable.

= For details, refer to Setting for rear view

camera on the previous page.

CAUTION

Pioneer recommends the use of a camera which

outputs mirror reversed images, otherwise the

screen image may appear reversed.

p Immediately verify whether the display

changes to a rear view camera image when

the gearstick is moved to REVERSE (R)

from another position.

p When the screen changes to full-screen

rear view camera image during normal

driving, switch to the opposite setting in

“Polarity”.

1 Display the “System Settings” screen.

= For details, refer to Displaying the “System

Settings” screen on page 127.

2 Touch [Back Camera].

The “Back Camera Settings” screen appears.

3 Touch [Camera] change the setting to

“On”.

p You can only switch to “Rear View” if this

setting is “On”.

4 Touch [Polarity] to select an appropriate

setting for polarity.

Each time you touch [Polarity] switches be-

tween the following polarity:

! Battery: When the polarity of the con-

nected lead is positive while the gearstick is

in the REVERSE (R) position

! GND: When the polarity of the connected

lead is negative while the gearstick is in the

REVERSE (R) position

Adjusting the response

positions of the touch panel

(touch panel calibration)

If you feel that the touch panel keys on the

screen deviate from the actual positions that

respond to your touch, adjust the response po-

sitions of the touch panel screen.

p Do not use a sharp pointed tool such as a

ballpoint pen or a mechanical pen, which

could damage the screen.

1 Display the “System Settings” screen.

= For details, refer to Displaying the “System

Settings” screen on page 127.

2 Touch [Screen Calibration].

A message confirming whether to start the ca-

libration appears.

3 Gently touch the centre of + mark dis-

played on the screen.

The target indicates the order.

After you touch all marks, the adjusted posi-

tion data is saved.

p Do not turn off the engine while saving the

adjusted position data.

# Press the MODE button.

Returns to the previous adjustment position.

# Press and hold the MODE button.

Cancels the adjustment.

Engb

132

Chapter

26

Customising preferences

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 187 188

Commentaires sur ces manuels

Pas de commentaire