Pioneer Premier DEH-P410UB Manuel d'utilisateur Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 187
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
! If the front panel is not detached from the
head unit within five seconds of turning off
the ignition, a warning tone sounds.
! You can turn off the warning tone. See
Switching the warning tone on page 29.
Important
! Handle gently when removing or attaching
the front panel.
! Avoid subjecting the front panel to excessive
shock.
! Keep the front panel out of direct sunlight and
high temperatures.
Removing the front panel
1 Press DETACH to release the front
panel.
2 Grab the front panel and remove.
Attaching the front panel
1 Slide the front panel to the left until it
clicks.
Front panel and the head unit are jointed on
the left side. Make sure that the front panel
has been jointed to the head unit.
2 Press the right side of the front panel
until it is firmly seated.
# If you cant attach the front panel to the head
unit successfully, try again. Front panel may be
damaged if you attach the front panel forcedly.
About the demo mode
This unit features the feature demo mode.
Important
! The red lead (ACC) of this unit should be con-
nected to a terminal coupled with ignition
switch on/off operations. If this is not done,
the vehicle battery may be drained.
! Before detaching, be sure to remove the AUX
cable from the front panel. Otherwise, this
unit, connected device or vehicle interior may
be damaged.
Feature demo mode
The feature demo automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON. Press DISP
during feature demo operation to cancel the
feature demo mode. Press DISP again to start.
Remember that if the feature demo continues
operating when the car engine is turned off, it
may drain battery power.
Use and care of the remote
control
Installing the battery
Slide the tray on the back of the remote con-
trol out and insert the battery with the plus (+)
and minus () poles aligned properly.
! When using for the first time, pull out the
film protruding from the tray.
<
YRD5266-B/S>8
Before You Start
En
8
Section
01
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 186 187

Commentaires sur ces manuels

Pas de commentaire