Pioneer KEH-P5900R Manuel d'utilisateur télécharger pdf (Page 8)



&RQQHFWLQJWKH 8QLWV

Connection in a car featuring an ISO Connector

You can connect the car stereo power cord as it is.

(Do not use the power cord supplied with this unit.)

Attention:

The connector wiring may vary depending on the car manufacturer, even when ISO connectors

are used. We recommend to check the car’s wiring provision before connecting the car stereo.

Please pay particular attention to pin 5, where a misconnection might cause damage to the car or

radio.

Take special care when installing into ’98 or later VW/Audi/Skoda/Seat models as there may be

a 12 V connection on Pin 5, which could damage the car stereo or into Ford from ’97 or later,

with an ISO connector, on which damage to the car’s microcomputers is possible if

misconnected. Use of ISO connector adapters available on the market may facilitate installation.

Refer to "Connection in a car not featuring an ISO Connector."

Accessory

To electric terminal controlled by ignition

switch (12 V DC)

ON/OFF.

Back-up

To terminal always supplied

with power regardless of

ignition switch position.

Switch

Car stereo power cord.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

Pas de commentaire

Pioneer KEH-P5900R Manuel d'utilisateur Page 8