Pioneer AVIC X3 Manuel d'opérations Page 115

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 164
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 114
113
Chapter 8 Customising the AV Source SettingAV
Initial Settings
Adjusting initial settings
Initial settings lets you perform initial set up of
different settings for navigation system.
(1) Function display
1 Touch “OFF” in the AV Source screen to
turn source off.
“Selecting an AV source” Page 28
2 Press the MENU button to change to the
AV MENU.
3 Touch “Initial”.
Setting the FM tuning step
Normally the FM tuning step employed by seek
tuning is 50 kHz. When AF or TA is on, the tuning
step automatically changes to 100 kHz. It may be
preferable to set the tuning step to 50 kHz when
AF is on.
1 Touch “FM Step” in the Initial menu.
Each time you touch “FM Step” will switch
the FM tuning step between 50 kHz and 100
kHz while AF or TA is on.
The tuning step remains at 50 kHz during
manual tuning.
Switching Auto PI seek
The unit can automatically search for a different
station with the same programming, even during
preset recall.
1 Touch “Auto PI” in the Initial menu.
Touching “Auto PI” switches between “On
and “Off”.
Setting the rear output and sub-
woofer controller
This navigation system’s rear output (rear speaker
leads output and RCA rear output) can be used for
full-range speaker (
Rear SP
Full
) or subwoofer
(
Rear SP
Sub. W
) connection. If you switch the
rear output setting to the
Rear SP
Sub. W
, you
can connect a rear speaker lead directly to a sub-
woofer without using an auxiliary amp.
Initially, the navigation system is set for rear full-
range speaker connection (Rear SP Full). When
rear output is connected to full range speakers
(when Rear SP Full is selected), you can con-
nect the RCA subwoofer output to a subwoofer.
In this case, you can select whether to use the
subwoofer controller’s (low pass filter, phase)
built-in Preout Sub. W or the auxiliary Preout
Full.
1 Touch “Rear SP” in the Initial menu.
2 Touch “Rear SP” to switch the rear out-
put setting.
When no subwoofer is connected to the rear
output, select Full.
When a subwoofer is connected to the rear
output, select Sub. W.
When the rear output setting is Sub. W,
you cannot change the subwoofer control-
ler.
3 Touch “Preout” to switch the subwoofer
output or non fading output.
Even if you change this setting, there is no
output unless you turn “Non Fading” or
Sub Woofer” in the Sound menu “On”.
“Using non fading output” Page 109
“Using subwoofer output” Page 109
If you change the subwoofer controller
(Rear SP), the subwoofer output (Sub
Woofer) and non fading output (Non Fad-
ing) in the Sound menu return to the fac-
tory settings.
Both rear speaker leads output and RCA
rear output are switched simultaneously in
this setting.
(1)
Initial Settings
MAN-AVIC-X3-EN.book Page 113 Wednesday, June 6, 2007 10:15 AM
Vue de la page 114
1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 163 164

Commentaires sur ces manuels

Pas de commentaire