Pioneer VSX-1015-K Manuel d'utilisateur télécharger pdf (Page 48)

The System Setup menu

Note

• If you are using a Sound Pressure Level (SPL) meter,

take the readings from your main listening position

and adjust the level of each speaker to 75 dB SPL (C-

weighting/slow reading).

• The subwoofer test tone is output at low volumes. You

may need to adjust the level after testing with an

actual soundtrack.

5 When you’re finished, press RETURN.

You will return to the Manual SP Setup menu.

Tip

• You can change the channel levels at any time by

using

EFFECT/CH SEL

and

+/–

on the remote control.

You can set separate levels for the listening modes

(Standard, Home THX, Advanced and Stereo/Direct)

as well as for the

MULTI CH IN

mode. However, the

listening mode setting will be cleared if you use one

of the setups (for example, the System Setup or Auto

Setup) to set the channel levels at a later date.

Speaker Distance

For good sound depth and separation from your system,

you need to specify the distance of your speakers from

the listening position. The receiver can then add the

proper delay needed for effective surround sound.

1 Select ‘Speaker Distance’ from the Manual SP

Setup menu.

2 Adjust the distance of each speaker using the

/



(cursor left/right) buttons.

You can adjust the distance of each speaker in 0.1 meter

increments.

3 When you’re finished, press RETURN.

You will return to the Manual SP Setup menu.

Tip

• For best surround sound, make sure the surround

back speakers are the same distance from the

listening position.

Surround Back Speaker Position

For the most effective results when using the THX Select2

Cinema and THX MusicMode listening modes (see

Using

the Home THX modes

on page 32) with the Advanced

Speaker Array (ASA) system (see

About THX

on page 75),

it is required that you make the setting. See

THX speaker

system setup

on page 22 for more on this.

Note

• If you don't have surround back speakers, or just have

one, you won't be able to select this setting.

1 Select ‘THX Audio Setting’ from the Manual SP

Setup menu.

2 Specify the distance of your surround back

speakers from each other.

•

0–0.3 m

– Surround speakers within 30 cm apart

(best for THX surround sound).

•

>0.3–1.2 m

– Surround speakers between 30 cm and

1.2 m apart.

•

1.2 m<

– Surround speakers more than 1.2 m apart.

3 When you're finished, press RETURN.

You will return to the Manual SP Setup menu.

4. Manual SP Setup

[ a. Speaker Setting ]

[ b. Crossover Network ]

[ c. Channel Level ]

[ d. Speaker Distance ]

[ e . THX Audio Setting ]

4d. Speaker Distance

Left [ 2.0 m ]

Center [ 2.0 m ]

Right [ 2.0 m ]

Surround R [ 2.0 m ]

Surr Back R [ 2.0 m ]

Surr Back L [ 2.0 m ]

Surround L [ 2.0 m ]

Sub Woofer [ 2.0 m ]

4. Manual SP Setup

[ a. Speaker Setting ]

[ b. Crossover Network ]

[ c. Channel Level ]

[ d. Speaker Distance ]

[ e . THX Audio Setting ]

SBL–SBR

4e. THX Audio Setting

SB SP Position

[ 0 – 0.3m ]

VSX_1015.book.fm 48 ページ２００５年３月７日　月曜日　午後７時０分

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 77 78

Commentaires sur ces manuels

Pas de commentaire

Pioneer VSX-1015-K Manuel d'utilisateur Page 48

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs AV Pioneer VSX-1015-K