Pioneer DDJ-SR Manuel d'utilisateur télécharger pdf (Page 12)

7 Level indicator

Displays either the levels of the respective channels or the master

output level.

8 CROSS F. REV. indicator

Lights when the [CROSS FADER REVERSE] switch is set to the [ON]

side.

9 Crossfader

Switches between the audio output of the left and right decks.

a MASTER LEVEL control

Adjusts the master sound level output.

b HEADPHONES MIX control

Adjusts the balance of the monitor volume between the sound of the

channels for which the headphones [CUE] button is pressed and the

sound of the master channel.

c SAMPLER VOLUME control

Adjusts the sampler’s overall sound level.

Effect section

This section is used to control the two effect units (FX1 and FX2).

Controls and buttons to operate the FX1 unit are located on the left side

of the controller, those to operate the FX2 unit are located on the right

side of the controller. The channels to which the effect is to be applied

are set using the effect assign buttons .

1 2

4 5 6

7 8 9 a

1 FX ASSIGN 1 buttons

Turns effect unit FX1 on and off for the respective channel.

2 FX ASSIGN 2 buttons

Turns effect unit FX2 on and off for the respective channel.

3 Effect parameter 1 control

Adjusts the effect’s parameter 1.

4 Effect parameter 2 control

Adjusts the effect’s parameter 2.

5 Effect parameter 3 control

Adjusts the effect’s parameter 3.

6 FX BEATS control

Adjusts the effect time.

7 Effect parameter 1 button

Press:

Turns the effect on or off or switches parameter 1.

[SHIFT] + press:

Switches the effect type.

8 Effect parameter 2 button

Press:

Turns the effect on or off or switches parameter 2.

[SHIFT] + press:

Switches the effect type.

9 Effect parameter 3 button

Press:

Turns the effect on or off or switches parameter 3.

[SHIFT] + press:

Switches the effect type.

a TAP (FX MODE) button

Press:

The BPM used as the base value for the effect is calculated by the

interval at which the button is tapped with a finger.

When the button is pressed and held, the effect time is reset.

[SHIFT] + press:

Switches the effect mode.

= Using effects (p.20)

 To monitor the effect sounds

When the [HEADPHONES MIX] control is turned to the [CUE] side,

the Serato DJ software’s effect sounds are not output to the sound

of the channels whose headphones [CUE] button are pressed. If you

want to monitor the Serato DJ software’s effect sounds, turn the

[HEADPHONES MIX] control to the [MASTER] side and monitor the

effect sounds in the sound of the master output.

Reading the beat indicator

The beat set with the auto loop function and the beat set in the Pad

Plus mode are indicated by the beat indicator. In the hot cue roll mode,

for example, the beat indicator displays the number of beats that are

repeated.

For details, see Using the Pad Plus mode on page 23.

Indicator

Number of

beats

Indicator

Number of

beats

1/32 beat 1 beat

1/16 beat 2 beats

1/8 beat 4 beats

1/4 beat 8 beats

1/2 beat

! When 1/3 beat is selected with the Trans Pad function, this is not

indicated on the beat indicator.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Commentaires sur ces manuels

Pas de commentaire

Pioneer DDJ-SR Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Audio Pioneer DDJ-SR