Pioneer PDP-504CMX Manuel d'utilisateur télécharger pdf (Page 6)

5.5.4 Combination Connection

When performing control and adjustment, it is convenient to connect several sets to one PC.

By performing a combination connection and assigning IDs to the sets, it is possible to control and adjust several sets

at the same time or separately.

Connection method:

Connect the sets as shown in the figure below, and perform control and adjustment with the PC.

Only the combination IN terminal or RS-232C terminal can be used at the same time on one set. Connecting them at

the same time could cause erroneous operation or be the cause of trouble, so do not connect them at the same

time. Also, do not connect pair of combination IN terminals or combination OUT terminals. Doing so could cause

trouble.

It is possible to use a general-purpose mini DIN 6-pin (straight) cable for the combination cable.

Note

To output RS-232C signals from the combination OUT terminal, an ID must be assigned.

For details, refer to section, 5.5.3, ‘ID Assignment’.

RS-232C Adjustment Mode

232

First set

Second set

Third set

Combination cable

OUT

Note

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Pas de commentaire

Pioneer PDP-504CMX Manuel d'utilisateur Page 6