Pioneer VSX-452 Manuel d'utilisateur Page 23

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 24
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 22
TROUBLESHOOTING
Symptom.
High noise level.
Remedy
Tune the station in correctly.
Cause
Station has not been tuned in to correct
frequency.
Antenna has not been connected or has become
disconnected.
FM reception
Accessory FM antenna remains bundled up or it
is not pointing in right direction.
Weak broadcasting station signals.
Connect the antenna securely.
Stretch the antenna taut and locate direction
yielding optimum reception.
Replace accessory FM antenna with outdoor
FM antenna.
AM reception
AM loop antenna is not pointing in right direction. Change the direction of AM loop antenna and
find a position where reception is improved.
Weak broadcasting station signals. Erect outdoor AM antenna or connect ground
wire.
Noise being picked up from this unit and other Stop using appliances generating noise or remove
equipment (especially electrical appliances using them from vicinity of the stereo equipment.
motors or fluorescent lights). Separate the loop antenna from the unit by some
distance.
When in Auto tuning, it does Input signals are not strong enough.
not stop automatically.
"IV source can not be seen when
the VCR's TV tuner is used.
No rear sound is produced.
"IV antenna is not connected to VCR, or
connections are faulty.
You are attempting to watch e TV source using
e VCR with copy system connections.
In general, when copy system connections are
made, the VCR's TV tuner function ceases to
operate. For details, consult the operating
instructions for your VCR.
The SURROUND MODE selector button is set
incorrectly.
The REAR LEVEL is turned down.
Speaker connecting wires are disconnected
from REAR SPEAKERS terminals.
Batteries are dead or no batteries in remote
control unit.
Poor angle or too great a distance from the
remote sensor window.
There is an obstacle between you and the
remote sensor window.
A fluorescent light is shining on the remote
sensor window.
Remote control does not work.
(FM) If the supplied simple antenna is being used,
change to an outdoor antenna.
Consult the VCR's operating instructions, and
connect antenna correctly.
Disconnect the copy system connection (TV
tuner function will operate).
Set correctly.
Adjust the rear level with the remote control
unit's REAR LEVEL buttons.
Connect wires to terminals securely.
Insert new batteries.
Use within 7 meters (23 feet) and within a 30
degree angle of the remote sensor window.
Change your position or move the obstacle.
Move so fluorescent light does not shine directly
on amplifier front panel remote sensor window.
Abnormal functioning of this unit may be caused by lightning, static
electricity, or other external interference. To restore normal operation,
turn the power off and then on again, or unplug the AC power cord
and then plug ff in again.
23
<ARB1424>
Vue de la page 22
1 2 ... 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire