Pioneer DVD-204 Manuel d'utilisateur télécharger pdf (Page 14)

At this point, you may use the Pioneer DVD player's con-

trols as you normally would, to find the exact frame on

the disc to begin your button sequence. In this example,

let's say frame "5678". After the start frame is located

on the DVD, press button 1 on the DVD-204 /DVD-212. As

mentioned earlier, only button 1 will be flashing now.

Upon pressing button 1, the following screen will appear:

Button: 3

Select new END frame.

Use player front panel

or remote control

Press 1 to select.

End

1 2 3 4

Using the same procedure as used in finding the start

frame, use the player's controls to locate the last frame

of the sequence. For this example, let's say frame "5800".

Press button 1, which will be flashing, when you are done.

In this example, the screen will now be reading:

Button 3 plays

Frames: 5678 to 5800.

Change this?

Yes No

1 2 3 4

Since these are the desired settings, we press button 4 to

indicate that no change is desired (Here, frames 5678 and

5800 are used as an example, in reality, the actual frame

numbers would be displayed).

The screen will now revert to the main menu where we

began. Use the above technique to program the remaining

buttons. It is not necessary to program more buttons than

you are using. If your application calls for just one but-

ton, that is all that needs to be programmed. When you

have finished all programming, return to the main menu and

press the red "Program" button on the back of the DVD-204

/DVD-212, which

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Pioneer DVD-204 Manuel d'utilisateur Page 14