Pioneer SC-LX79 Manuel d'utilisateur télécharger pdf (Page 9)

Before you start

Put the batteries in the remote control.

Switch on the receiver and your TV.

ALL ZONE STBY

SOURCE

STANDBY/ON

MAIN

SUB ZONE CONTROL

SOURCE CONTROL

Z2 Z3 HDZ

HDMI

RECEIVER

Switch the TV input so that it connects to the

receiver.

Turn the subwoofer on and turn up the

volume.

CAUTION

• Do not use or store batteries in direct sunlight or other

excessively hot place, such as inside a car or near a

heater. This can cause batteries to leak, overheat, explode

or catch fire. It can also reduce the life or performance of

batteries.

• When inserting the batteries, make sure not to damage

the springs on the battery’s

terminals. This can cause

batteries to leak or overheat.

• When disposing of used batteries, please comply with

governmental regulations or environmental public

institution’s rules that apply in your country/area.

Automatically setting up for surround sound (MCACC)

The Auto Multi-Channel ACoustic Calibration (MCACC) setup

uses the supplied setup microphone to measure and analyze

the test tone that is outputted by the speakers.

Important

• Measure in a quiet environment.

Connect the supplied setup microphone.

• If “

Please wait…

” appears on the display of the receiver

after the setup microphone is connected, pull out

the setup microphone from the receiver and wait for

approximately a minute, and then connect the microphone

to the receiver again.

• Set to ear height when using a tripod etc., for the

microphone.

MASTER

VOLUME

STANDBY/ON

INPUT

SELECTOR

MCACC

SETUP

MIC

The

Full Auto MCACC

screen appears on your TV.

Speaker System : 7.2.2/5.2.2/7.2ch

Exit

2a.Full Auto MCACC

Return

START

EQ Type : SYMMETRY

SP to ceiling : – – –

MCACC : M1.MEMORY 1

Dolby Enabled Speaker

: NO

Measurement Type : Expert

Press MAIN RECEIVER on the remote control,

then press the ENTER button.

• Automatic measuring will start.

• Measuring will take about 3 to 12 minutes.

Follow the instructions on-screen.

• Automatic setting is complete when the Home Menu

screen appears.

Exit

System

Setup

MCACC

PRO

HOME MENU

Network,

Bluetooth

• If

Reverse Phase

is displayed, the speaker’s wiring (+ and –)

may be inverted. Check the speaker connections.

Even if the connections are correct,

Reverse Phase

may be

displayed, depending on the speakers and the surrounding

environment. This does not affect measurements, however,

so select

Go Next

• If

ERR

is displayed, check that speaker is properly connected.

• When the power turns off, refer to the “Frequently asked

questions” in the booklet.

Make sure the setup microphone is

disconnected.

Initial Setup

Setup microphone

Tripod

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 75 76

Commentaires sur ces manuels

Pas de commentaire

Pioneer SC-LX79 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes vidéo pour voitures Pioneer SC-LX79