Pioneer DJM-400 Manuel d'utilisateur Page 12

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 11
12
EFFECT FUNCTIONS (IN-LOOP SAMPLER/EFFECT PARAMETERS)
5.At the point you wish to sample record, press one of the
non-lighted BEAT/BANK buttons.
Lighted
BEAT/BANK
buttons have already been recorded, and
cannot be used again unless their recorded contents are
erased.
Recording begins automatically when the sound signal from
CD player or other component is detected. During recording,
the
BEAT/BANK
button will flash quickly. During recording
standby, the button will flash slowly at intervals.
When 4 beats of sound at the measured BPM have been
recorded, the
BEAT/BANK
button flashes slowly and loop play
is performed.
6. If the beat becomes unsynchronized, press one of the
BEAT/PITCH buttons (, +) to resynchronize the timing of
the playback sample to the currently playing track.
The playback speed increases while the [+] button is
depressed, and decreases while the [] button is depressed.
7.Rotate the LEVEL/DEPTH dial to adjust the sound balance
between source and sample.
8. To stop loop playback, press the corresponding
BEAT/
BANK
button.
The
BEAT/BANK
button indicator will change from slow
flashing to steadily lighted.
[To Playback a Recorded Sample]
1 Set the effect selector switch to [IN-LOOP SAMPLER].
2 Use the effect channel selector to choose the channel for
loop playback.
3 Set the ON/OFF button to ON.
4 Press the BEAT/BANK button containing the sample you
wish to play as a loop.
The BEAT/BANK buttons with recorded samples are lighted.
The selected button will flash slowly and loop play will begin.
5 If the beat becomes unsynchronized, press one of the
BEAT/PITCH buttons (, +) to resynchronize the timing of
the playback sample to the currently playing track.
The playback speed increases while the [+] button is
depressed, and decreases while the [] button is depressed.
6 Rotate the LEVEL/DEPTH dial to adjust the sound balance
between source and sample.
7 To stop loop playback, press the corresponding
BEAT/
BANK
button.
The
BEAT/BANK
button indicator will light steadily.
[Erasing a Recorded Sample]
1 Set the effect selector to [IN-LOOP SAMPLER].
2 While holding the ERASE (BEAT/PITCH ) button
depressed, press the
BEAT/BANK
button containing the
sample you wish to erase.
The BEAT/BANK buttons containing recorded samples are lighted.
The indicator in the selected BEAT/BANK button will go out
and the sample will be erased.
EFFECT PARAMETERS
8. IN-LOOP SAMPLER
This function allows you to store 4-beat sounds in up to 5
banks, then output them repeatedly.
Example
Repeat
Bank 1
Present
track
BPM=125
Vue de la page 11
1 2 ... 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire