Pioneer S-H210V Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Systèmes de cinéma à domicile Pioneer S-H210V. Pioneer S-H210V User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
S-H210V
SPEAKER SYSTEM
ENCEINTE ACOUSTIQUE
LAUTSPRECHERSYSTEM
SISTEMA ALTOPARLANTE
LUIDSPREKERSYSTEEM
HÒGTALARSYSTEM
SISTEMA DE ALTAVOCES
SISTEMA DE ALTIFALANTES
OPERATING GUIDE
MODE D’EMPLOI
BEDIENUNGSANLEITUNG
GUIDA PER luso
GEBRUIKSAANWIJZING
BRUKSANVISNING
GUÍA DE OPERACIÓN
GUIA DE OPERAgÄO
( English )
BEFORE OPERATION
Thank you for buying this PIONEER product.
Read the operating instructions carefully before using these speakers
so that you can operate thenn properly. After you have finished reading
the instructions, put them away in a safe place for future reference.
The rated impedance of these speakers is 8 Ohm. They must be
connected to a stereo amplifier which accepts this type of load
(miminum and maximum impedances accepted by the amplifier are
generally indicated near the loudspeaker outlets : for example "4-16
Q!'
or "6-16 il").
To guard against damage to these speakers due to an electric power
overload, take the following precaustions :
o Do not supply more than the maximum permitted power to the
speakers (see Specifications).
o Any connection or switching on or off of part of the audio system
(CD player, tuner etc.) must be carried out after switching off the
amplifier or at least with the loudspeaker outlets disconnected (if
the amplifier allows). Interference caused by these operations
will otherwise reach the speakers and may damage the treble
loudspeaker units.
o When boosting particular frequencies using a graphic equaliser
or bass and treble correctors, make sure that you do not increase
the amplifier volume excessively, as the speakers will be
overloaded more quickly.
o Do not force a low-power amplifier to produce a high level of
sound as harmonic distortion increases rapidly in this situation and
may pose a danger to the treble loudspeaker units.
Avoid touching the diaphragms and suspensions of loudspeakers
as they are fragile.
© Strip the insulation at
the tip of the cord and
twist the strands
The loudspeaker units in these speakers are magnetically shielded.
However, colours may blur if the speakers are positioned too close
to a television screen. If this happens, switch off the television and
switch it back on again after 15 to 30 minutes. If the problem
persists, move the speakers away from the television set.
INSTALLATION PRECAUTIONS
Do not install these speakers close to an oven or heating appliance.
Avoid exposing them to direct sunlight. High temperatures can distort
the structure of the enclosure and adversely affect the sound.
These speakers are heavy and fragile, and it is therefore dangerous
to install them in an unstable position.
For optimum sound reproduction of high frequencies, the treble
loudspeaker units must be at the same height as the listener’s ears.
For low frequencies, it is possible to increase the level of bass sounds
by positioning the speakers close to a wall (the maximum increase
being obtained for a position in a corner of the listening room).
CONNECTIONS
1. Switch off the amplifier power supply (OFF).
2. Connect the cables to the input terminals on the rear of the speakers.
Connect the neutral cable to the terminal and the live cable to the
"+" terminal. Do not forget that the red input terminal has positive
polarity and that the black input terminal has negative polarity.
3. Connect the cables to the loudspeaker outlet terminals of the
amplifier. Connect the live cable to the "-f" terminal and the neutral
cable to the terminal.
(D Depress the imput terminal lever,
and insert the tip of the cord into the
hole and then release the lever so
that it springs back into position.
(D Connect the common-
side speaker cord tho the
© terminal.
@ Connect the hot-side speaker
cord tho the © terminal.
REMARKS:
Check that the cables are securely connected to the terminals. A
loose connection may cause not just Intermittent or distorted sound
but short-circuiting and breakdown of the amplifier.
If the cables of one of the speakers have been connected with the
wrong polarities, you will find when listening to a stereo recording that
bass sounds are weakened and the stereo effect normally obtained
between the two speakers does not exist.
MAINTENANCE OF THE ENCLOSURE
• Use a cloth to wipe away dust and dirt.
If the enclosure is very dirty, wipe with a soft cloth dipped in a neutral
detergent diluted five to six times with water, then wipe again with the
dry cloth. Do not use thinner, benzene, cleaning sprays or other
chemical products on or near the enclosures as the surfaces could be
adversely affected.
SPECIFICATIONS
Speaker
...............................................................
bookshelf type, enclosed
System : Centre speaker...................................2-way, 3 loudspeaker units
Loudspeaker units : Bass
.............................
2 cone woofers, 13 cm
Treble
...........................
1 cone tweeter, 5,2 cm
Rated impedance
............................................................................................
8 W
Frequency range (-3 dB)........................................................50 - 20000 Hz
Sensitivity ............................................................90 dB/W at 1 m distance
Music power (DIN): ..................................................................................80 W
External dimensions
...........................
166 x 612 x 188 mm (W x H x D)
Weight............................................................................................................4,2 kg
Accessories
Operating instructions
..................................................................................
1
Warranty..........................................................................................................1
Cables..............................................................................................................2
REMARK:
The specifications and design of this product are subject to change
without notice, in the interests of improvements.
Published by Pioneer Corporation.
© 2000 Pioneer Corporation.
All reproduction and translation rights reserved.
Vue de la page 0
1 2 3 4 5 6 7 8

Résumé du contenu

Page 1

S-H210VSPEAKER SYSTEM ENCEINTE ACOUSTIQUE LAUTSPRECHERSYSTEM SISTEMA ALTOPARLANTE LUIDSPREKERSYSTEEM HÒGTALARSYSTEM SISTEMA DE ALTAVOCES SISTEMA

Page 2

( DeutschVOR GEBRAUCH• Vielen Dank, dass Sie dieses Produkt von PIONEER gekauft haben.• Lesen Sie bitte aufmerksam die Gebrauchsanweisung, bevo

Page 3 - ® Collegare il cavo

Italiano )PRIMA DELL’USO• Grazie per aver acquistato questo prodotto PIONEER.• Prima di utilizzare queste casse acustiche, leggere attentamen

Page 4

(^Nederlands)VOOR НЕТ GEBRUIK• Dank u voor uw aankoop van dit PIONEER product.• Lees deze gebruiksaanwijzing aandachtig alvorens deze luidspre

Page 5

(Svenska)FORE ANVANDNING• Tack for att du valt en produkt frán PIONEER.• Las bruksanvisningen noggrant innan du anvander dessa hógtalarládor,

Page 6 - Ç Español ^

Ç Español ^OBSERVACIONES GENERALES• PIONEER aprecia su confianza en este producto.• Lea atentamente las instrucciones para utilizar idealmente

Page 7 - Ç Portugués ^

Ç Portugués ^ANTES DE UTILIZAR• Agradecemos-lhe o ter comprado este produto PIONEER.• Leia atentamente o modo de utilizagao antes de utilizar estas c

Page 8 - France : Tapez 36 15 PIONEER

(^Français)AVANT UTILISATION• Merci d'avoir acheté ce produit PIONEER.• Lire attentivement le mode d'emploi avant d'utiliser c

Commentaires sur ces manuels

Pas de commentaire