Pioneer X-NM1 Manuel d'utilisateur télécharger pdf (Page 34)

Additional Information9

Demo display

This system features a demonstration display. When the

demo mode is on, the demo display automatically starts

after the system is inactive for several minutes.

1 Switch the system into standby.

2 Press ENTER for about three seconds.

The demonstration mode will be displayed.

3 While the demostration mode is

displayed, press ENTER again for about

three seconds.

The demonstration mode is switched off and the system

returns to standby. If the demo mode has been switched

off already, this will turn it back on.

If the AC power is cut (blackout, accidentally

unplugging the power cord) for over 4 hours, the system

will default to the demo mode.

Changing the brightness level

• Press CLEAR for about three seconds to

change the brightness level.

The display shows either

DIMMER ON or DIMMER

OFF.

Changing the frequency step

If you find that you can’t tune in to stations successfully,

the frequency step might not be suitable to your

country/region. Here’s how to switch the setting:

1 Switch the power into standby.

2 Press and hold 7 for about four seconds.

3 Use ∞ and 5 to choose a new frequency

step.

Switch between 9 kHz/50 kHz and 10 kHz/100

kHz settings. Press 7 at any time to cancel and exit the

menu.

4 Press ENTER twice to confirm the setting.

Changing the frequency step will delete all of your

station presets.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 79 80

Pas de commentaire

Pioneer X-NM1 Manuel d'utilisateur Page 34