Pioneer XW-NAS3 Manuel d'utilisateur télécharger pdf (Page 6)

Before you start01

6

En

Chapter 1:

Before you start

What’s in the box

Please confirm that the following accessories

are in the box when you open it.

• Remote control

• Remote control holder

• Lithium battery (CR2025)

•Power cord

•

Cleaning cloth

• Operating instructions (This document)

Before using the remote control

The remote control is shipped already set in the

remote control holder.

The battery supplied with this unit is stored in

the battery casing.

• Remove the protective seal from the

battery casing.

When you notice a decrease in the operating

range, replace the battery (see below).

Replace the battery

When replacing the battery, use a

commercially available Lithium CR2025

battery.

1 Push the release tab to the left to open

the battery casing.

2 Pull out the battery casing.

3 Remove the battery from the casing.

4 Place a new battery in the casing.

Make sure the  side of the battery is facing up

when you place it in the space provided.

Caution

When using lithium batteries, please observe

the following:

• There is danger of explosion if the battery is

incorrectly replaced. Make sure to replace

only with the same or equivalent type

recommended by the manufacturer.

• Dispose of used battery cells immediately

after replacement. Keep away from

children.

• If swallowed, please contact a doctor

immediately.

• Lithium batteries may present a fire or

chemical burn hazard if misused. Do not

disassemble, heat above 100 °C, or

incinerate.

1

1

3

2

XW-NAS3_CUXJ.book 6 ページ２００９年１２月２４日　木曜日　午後１時４７分

1 2 3 4 5 6 7 8 9 10 11 ... 59 60

Commentaires sur ces manuels

Pas de commentaire