Pioneer DEH-2300 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Acoustique Pioneer DEH-2300. Pioneer DEH-2300 User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 6
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Note:
This unit is for vehicles with a 12-volt battery
and negative grounding. Before installing it in a
recreational vehicle, truck, or bus, check the bat-
tery voltage.
To avoid shorts in the electrical system, be sure
to disconnect the battery cable before begin-
ning installation.
Refer to the owner’s manual for details on con-
necting the power amp and other units, then
make connections correctly.
Secure the wiring with cable clamps or adhesive
tape. To protect the wiring, wrap adhesive tape
around them where they lie against metal parts.
Route and secure all wiring so it cannot touch
any moving parts, such as the gear shift, hand-
brake and seat rails. Do not route wiring in
places that get hot, such as near the heater outlet.
If the insulation of the wiring melts or gets torn,
there is a danger of the wiring short-circuiting to
the vehicle body.
Don’t pass the yellow lead through a hole into
the engine compartment to connect to the battery.
This will damage the lead insulation and cause a
very dangerous short.
Do not shorten any leads. If you do, the protec-
tion circuit may fail to work when it should.
Never feed power to other equipment by cutting
the insulation of the power supply lead of the
unit and tapping into the lead. The current capac-
ity of the lead will be exceeded, causing over-
heating.
When replacing fuse, be sure to use only fuse of
the rating prescribed on this unit.
Since a unique BPTL circuit is employed, never
wire so the speaker leads are directly grounded or
the left and right speaker leads are common.
Speakers connected to this unit must be high-
power types with minimum rating of 45 W
(50 W)* and impedance of 4 to 8 ohms.
Connecting speakers with output and/or imped-
ance values other than those noted here may
result in the speakers catching fire, emitting
smoke, or becoming damaged.
* DEH-2300 and DEH-23
When this product’s source is switched ON, a
control signal is output through the blue/white
lead. Connect to an external power amp’s system
remote control or the car’s Auto-antenna relay
control terminal (max. 300 mA 12 V DC). If the
car features a glass antenna, connect to the anten-
na booster power supply terminal.
When an external power amp is being used with
this system, be sure not to connect the blue/white
lead to the amp’s power terminal. Likewise, do
not connect the blue/white lead to the power ter-
minal of the auto-antenna. Such connection could
cause excessive current drain and malfunction.
To avoid short-circuiting, cover the disconnected
lead with insulating tape. Especially, insulate the
unused speaker leads without fail. There is a pos-
sibility of short-circuiting if the leads are not
insulated.
If this unit is installed in a vehicle that does not
have an ACC (accessory) position on the ignition
switch, the red lead of the unit should be con-
nected to a terminal coupled with ignition switch
ON/OFF operations. If this is not done, the vehi-
cle battery may be drained when you are away
from the vehicle for several hours. (Fig.1)
Fig. 1
The black lead is ground. Please ground this lead
separately from the ground of high-current prod-
ucts such as power amps.
If you ground the products together and the
ground becomes detached, there is a risk of dam-
age to the products or fire.
Cords for this product and those for other prod-
ucts may be different colors even if they have the
same function. When connecting this product to
another product, refer to the supplied Installation
manuals of both products and connect cords that
have the same function.
No ACC positionACC position
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
S
T
A
R
T
O
F
F
Rear output
This product
Antenna jack
+
≠
+
≠
+
≠
+
≠
+
≠
+
≠
Blue/white
To system control terminal of the power amp or Auto-antenna
relay control terminal (max. 300 mA 12 V DC).
Connecting cords
with RCA pin plugs
(sold separately).
System remote control
Rear speakerRear speaker
Right
Front speaker
Rear speaker
White Gray
White/black
Green
Green/black
Gray/black
Violet
Violet/black
Front speaker
Rear speaker
Left
Perform these connections when using a
different amp (sold separately).
With a 2 speaker system, do not connect
anything to the speaker leads that are not
connected to speakers.
Yellow
To terminal always supplied
with power regardless of
ignition switch position.
Black (ground)
To vehicle (metal) body.
Red
To electric terminal controlled
by ignition switch (12 V DC)
ON/OFF.
Power amp
(sold separately)
Fuse
Connecting the Units
INSTALLATION MANUAL
MANUEL D’INSTALLATION
<ENGLISH>
Connection Diagram
DEH-2300
DEH-1300
DEH-23
DEH-12
<KKYLL/00G00000>
Printed in
Imprimé
<CRD3280-B/JS> UC
This product conforms to CEMA cord colors.
Le code de couleur des câbles utilisé pour ce produit
est conforme à CEMA.
Los colores de los cables este producto se conforman
con el código de colores CEMA.
Fig. 2
Vue de la page 0
1 2 3 4 5 6

Résumé du contenu

Page 1 - MANUEL D’INSTALLATION

Note:• This unit is for vehicles with a 12-volt batteryand negative grounding. Before installing it in arecreational vehicle, truck, or bus, check the

Page 2 - Diagramme de connexion

Remarque:• Cet appareil est conçu pour les véhicules équipésd’une batterie de 12 volts et d’une masse négative.Avant de l’installer dans un véhicule d

Page 3 - Diagrama de conexión

Nota:• Esta unidad está diseñada para vehículos con unabatería de 12 voltios y toma de tierra negativa.Antes de instalarla en un vehículo recreativo,

Page 4 - Installation

About the fixing screws for the front panel (DEH-2300 and DEH-23)If you do not operate the Detaching and Replacing the Front Panel Function, use the s

Page 5 - <FRANÇAIS>

InstallationRetrait de I’appareil (Fig. 5) (Fig. 6)Fig. 5Fig. 6CadreInsérez les clés d’extraction fourniesdans l’appareil comme illustré dans lafigure

Page 6 - <ESPAÑOL>

InstalaciónReitirar la unidad (Fig. 5) (Fig. 6)Fig. 5Fig. 6Inserte el pasador de liberación en elorificio de la parte inferior del marcoy tire del pas

Modèles reliés DEH-1300 | DEH-12 |

Commentaires sur ces manuels

Pas de commentaire