Pioneer VSW-1 Manuel d'utilisateur Page 7

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 44
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 6
7
<DRB1375> En
English
Troubleshooting
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think there is something wrong with this component,
check the points below. Sometimes the trouble may originate from another component. Thus, also check the other electrical appli-
ances also in use.
If the trouble cannot be rectified even after checking the following items, contact your dealer or nearest PIONEER service center.
Symptom Cause Remedy
Power doesnt turn on.
No images are seen.
Video images are not
synchronized when switching is
performed.
Color is distorted when
performing input switching.
This unit inputs do not change
when the DJ mixers fader lever
is operated.
DJ DVD player doesnt start
when DJ mixers fader lever is
Power cord is not connected.
Cables are not connected properly, or are
loose.
Connectors or plugs and jacks are dirty.
Monitor power is not turned on.
MODE SELECTOR switch setting differs
from the type of video signal (PAL/NTSC)
being played back.
Use of a long cable causes drop in signal
level or quality.
This units sync signal output is not
connected to the DJ DVD player, or is
loose.
The setting of the connection panels
CHROMA SYNC switch differs from the
type of video signal being played back.
DJ mixers fader start switch is in set to OFF.
This units AUTO button is set to OFF
(indicator is off).
DJ DVD players control cable is not
connected to this unit, or is loose.
DJ mixers fader start switch is set to OFF.
Control cables between DJ DVD player and
this unit, or between DJ mixer and the unit
are not connected properly, or are loose.
This units FADER START switch is set to
OFF.
Connect power cord to wall outlet.
Connect properly.
Clean connectors and plugs, jacks.
Turn on power to monitor.
Set the MODE SELECTOR switch to
match the type of video signal being
played (PAL/NTSC).
Change to shorter cables.
Connect properly.
Set the CHROMA SYNC switch to
match the kind of signal being played.
Set DJ mixers fader start switch to ON.
Press AUTO button to ON (indicator
lights).
Connect properly.
Set DJ mixers fader start switch to ON.
Connect control cables properly.
Press this units FADER START switch
to ON position.
Static electricity or other external interference may cause the unit to malfunction. To restore normal operation, turn the power off and
then on again.
Vue de la page 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

Commentaires sur ces manuels

Pas de commentaire